(version 1)

# SP1 edge-connector (J3): the gold fingers must reach the board edge to make
# contact in the GameCube slot, so copper-to-edge clearance is intentionally
# relaxed for this footprint only. This is by design, not a defect.
# Test BOTH items because the violated pair is (Edge.Cuts segment of J3) vs (pad
# of J3) - the edge segment is item A, the pad is item B.
(rule "SP1 gold fingers - allow copper to board edge"
	(condition "A.memberOfFootprint('J3') || B.memberOfFootprint('J3')")
	(constraint edge_clearance (min -0.5mm)))