(version 1)

# SP1 gold fingers must reach the board edge to contact the GameCube slot,
# so copper-to-edge clearance is intentionally relaxed for the connector
# footprint only. By design, not a defect. Mirrors the identical rule in
# ../re-bba-rb/re-bba-rb.kicad_dru for J3.
(rule "SP1 gold fingers - allow copper to board edge"
	(condition "A.memberOfFootprint('J1') || B.memberOfFootprint('J1')")
	(constraint edge_clearance (min -0.5mm)))

# JLCPCB manufacturing floor (same tier as the main board).
(rule "JLCPCB min copper clearance (0.09mm)"
	(severity error)
	(constraint clearance (min 0.09mm)))
(rule "JLCPCB min via/PTH drill (0.15mm)"
	(severity error)
	(constraint hole_size (min 0.15mm)))
(rule "JLCPCB min via pad diameter (0.25mm)"
	(severity error)
	(constraint via_diameter (min 0.25mm)))
(rule "JLCPCB min hole-to-hole spacing (0.2mm)"
	(severity error)
	(constraint hole_to_hole (min 0.2mm)))