libogc's EXI functions return '1 on success, <=0 on error', but every call
site tested '== 0'. A -1 error return therefore read as success, so a failed
EXI_Lock or EXI_Select would fall through and the subsequent transfer would
produce garbage reported as a misleading test failure rather than an EXI
error. All six call sites now test <= 0.
Also retries EXI_Lock for ~100 ms: it fails outright rather than blocking when
another subsystem holds the channel, and Swiss or a libogc driver may hold it
briefly -- without the retry a transient collision surfaces as a test failure.
Builds clean with devkitPPC 16.1.0 / GCC 16, no warnings: 172 KB .dol.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
gc_bba_test/ builds a .dol that drives the adapter over raw EXI from the
console and reports pass/fail per test on the TV, navigable with the pad.
Uses libogc's EXI API against EXI0:2 (Serial Port 1) rather than its bba
network driver: driving the register file directly gives each check its own
verdict, so a failure points at a specific register instead of at
'networking'. Six suites - identity, registers, reset/control, EXI link
integrity (including an EXI clock-index sweep), ethernet TX/RX, SPRAM/DMA
streaming.
Encodes the hardware lessons from bring-up so the app cannot mislead:
* the device ID is a one-shot cleared by the first NCRA reset, so it is
reported SKIP on a re-run rather than FAIL
* TI means the frame reached the W5100, NOT the wire - the TX test says so
* register reads clock exactly the requested length (over-clocking
desynchronises the next transaction)
* TXDATA is written one byte per transaction (eff_addr auto-increments)
.devcontainer/Dockerfile gains the devkitPro gamecube-dev group. devkitPro
publishes no .deb on GitHub, so this uses their installer script against
apt.devkitpro.org -- which is 403 from inside the running container's egress
but reachable from a host-side docker build. Rebuild the container to get it.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Roflin