Roflin
92f7d716d9
RXFrameAssembler ignored RRP entirely, so it lapped the reader: a traffic
burst overwrote pages the GC had not read, and the "descriptor" the driver
then parsed was frame data from whatever had replaced it. That is where the
hardware's 00 00 00 01 came from -- not a dropped write.
This is a product bug, not just a netboot one. Until now ANY burst could
corrupt a frame Swiss was midway through reading, with nothing to indicate it
had happened.
The assembler now takes the GC's read pointer and computes free space as
(rrp - rwp - 1) mod 15. On a frame start with fewer than 6 free pages -- the
worst case for 1518 bytes plus a 4-byte descriptor -- it enters DROP_FRAME,
discards to EOF, and pulses rx_overflow, which sets IR[7] (RBFI). That is the
bit the GC's IMR = 0x86 already enables, so a driver that loses a frame is
told so instead of reading corruption.
Deliberate details:
- rx_ready stays HIGH while dropping. Stalling the ethernet master instead
would back-pressure into the W5100's own buffer and turn a dropped frame
into a wedged receiver.
- Six pages are reserved up front because a frame's length is not known
until EOF. Starting with less risks running into unread data partway
through, which is worse than refusing cleanly.
- have_room is REGISTERED, not combinational. Feeding a mod-15 subtract and
comparator into the FSM branch cost real depth in `sync`, the domain with
the least margin: clk fell 27.8-32.2 -> 27.0-28.0 MHz. Registering it
restored 28.4-31.4. One cycle of staleness is harmless -- rwp moves only
at end-of-frame and rrp only when the GC writes it.
T4 proves the property that matters, and the negative control REPRODUCES THE
HARDWARE FAULT IN SIMULATION: with the check removed the unread page reads
back as [245, 248, 251, 254, ...] -- frame data where a descriptor belongs.
First time one of today's RX faults has been reproducible on this side rather
than inferred from the console. T4 also checks the receiver un-latches once
RRP advances, so a full ring cannot kill RX permanently.
Fixed a test artifact in the same pass: rx_overflow fires on the very tick
that consumes the EOF byte, inside send_frame, so polling for a 1-cycle pulse
afterwards missed it and a correctly-dropped frame looked like a stall. Both
pulses are now latched in the tick helper.
netboot also clears IR (including RBFI) at init so a stale bit is not
inherited from an earlier run.
--seeds 8: clk 28.4-31.4 MHz, EXI 55.2-62.7 MHz, 8/8 PASS. Best seed 4
(clk 31.39, EXI 61.85), flashed.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>