Roflin
a5ca8b0cda
The whole gc_bba_test suite now passes on a real GameCube: Identity (device ID 04 02 02 00, HIPR, NWAYS), Registers, Reset/control, EXI integrity (speed sweep ok=[1,1,1,1,1,1], per-speed dump clean at all six indices, raw reg dump 0x17 in slot 0), Ethernet, and SPRAM/DMA -- at the real 27 MHz EXI rate. The one reported failure was t_raw_id, and it was not a fault: an earlier suite had already issued the NCRA reset that clears id_phase, after which address 0 correctly reads back NCRA. t_devid already guarded for this; t_raw_id did not, so a full run cried wolf. It now returns SKIP like t_devid, and both messages say reflash/reset the FPGA rather than power-cycle the console, which is what actually restores id_phase. CLAUDE.md records the device-ID fix and, importantly, that simulation CANNOT reproduce the bug it fixed -- bba_top passed the ID at EXI_HALF=1 beforehand, because sim's sync-to-EXI latency ratio does not match silicon closely enough to miss a 296 ns window. Anyone "simplifying" the ID back into the register file will keep a green suite and break hardware. Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>