From the physical V2 bring-up session (2026-09-20):
- exi_bba/w5100_selftest.py (NEW): standalone FPGA<->W5100 bus diagnostic.
Clock-independent data-bus walk (direct-mode GAR0 read-back, all 8 lines) +
MR software-reset self-clear (needs the 25 MHz crystal). Reports 4 verdicts on
D6/D7 LEDs AND over UART (115200): GOOD / data-line-N / clock-dead / no-response.
Boot wait is 85 ms (> the W5100S 60.3 ms init). On this board: GOOD -- bus +
all 8 data lines + 25 MHz clock all verified (unlike V1's broken D3).
- REVIEW.md / TODO.md: eFuse U13 OVLO is tied to GND, which on the TPS25961
selects the internal FIXED ~6 V overvoltage cutoff -- so it blocks the 12 V
rail entirely (bench-confirmed: 12V_EXI=0, GC_ON=0, W5100 unpowered). FAB-
BLOCKER for V2.1: fix with an OVLO divider (~1.1M/100k -> trip ~15 V). Bench
workaround: lift U13 pin 2 (OVLO) off GND. Also closed the eFuse-placement,
GND-via/3V3-zone, and CC-ESD TODO items.
- hardware/re-bba-rb/exi_devid_spi.py (NEW): Pi hardware-SPI (~25 MHz) EXI
device-ID host, companion to the bit-bang exi_devid_rpi.py.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
