From the physical V2 bring-up session (2026-09-20):
- exi_bba/w5100_selftest.py (NEW): standalone FPGA<->W5100 bus diagnostic.
Clock-independent data-bus walk (direct-mode GAR0 read-back, all 8 lines) +
MR software-reset self-clear (needs the 25 MHz crystal). Reports 4 verdicts on
D6/D7 LEDs AND over UART (115200): GOOD / data-line-N / clock-dead / no-response.
Boot wait is 85 ms (> the W5100S 60.3 ms init). On this board: GOOD -- bus +
all 8 data lines + 25 MHz clock all verified (unlike V1's broken D3).
- REVIEW.md / TODO.md: eFuse U13 OVLO is tied to GND, which on the TPS25961
selects the internal FIXED ~6 V overvoltage cutoff -- so it blocks the 12 V
rail entirely (bench-confirmed: 12V_EXI=0, GC_ON=0, W5100 unpowered). FAB-
BLOCKER for V2.1: fix with an OVLO divider (~1.1M/100k -> trip ~15 V). Bench
workaround: lift U13 pin 2 (OVLO) off GND. Also closed the eFuse-placement,
GND-via/3V3-zone, and CC-ESD TODO items.
- hardware/re-bba-rb/exi_devid_spi.py (NEW): Pi hardware-SPI (~25 MHz) EXI
device-ID host, companion to the bit-bang exi_devid_rpi.py.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Devcontainer now grants libusb access to the FT2232H so iceprog (bitstream) and
pyftdi (FT2232H EEPROM) run inside the container:
- devcontainer.json: --privileged + /dev/bus/usb bind mount
- Dockerfile: sudo (NOPASSWD for vscode; USB nodes are root-owned), libusb-1.0-0,
libftdi1-2, pyftdi
Add the flash-re-bba-rb skill documenting the procedure (bitstream via best swept
seed, optional EEPROM string, troubleshooting, guardrails) and
flash_ftdi_eeprom.py (pyftdi, backup-first, dry-run default) + ftdi_eeprom.conf
value spec.
Bring-up on the repaired V1 unit: bitstream flash VERIFY OK (iceprog
build/seed4/top.bin, capture 58.36 MHz). EEPROM product string CANNOT be
programmed on V1 — U7 is a 93LC46B (128 B), too small for the FT2232H, which
needs a 93LC56B (256 B); the 128 B chip mirrors and the config write fails
verify. This overturns the old REVIEW note "93LC46B = correct for FT2232H"
(that only checked ORG, not size). Board still works blank -> ROM defaults;
iceprog + UART unaffected. Documented in REVIEW.md + TODO.md (swap U7->93LC56B
for V2); flash_ftdi_eeprom.py detects the mirroring and refuses the write.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Roflin
Dennis Brentjes