Read from the two drivers that will actually talk to this device: libogc
(libdb/uIP/bba.c) and Swiss (cube/patches/bba/bba.c). The implemented 2-byte
header with a 2-bit length field does not match either.
The real protocol has two address spaces selected by bit 7 of byte 0, and no
length field at all -- the data phase runs until CS:
COMMAND (6-bit reg) one 4-byte readwrite; response in byte 3
REGISTER (16-bit reg) [0x80|w<<6, reg>>8, reg&0xFF, 0x00] + data phase
NCRA, IR, NWAYS, RWP, RRP and PAR all live in the register space. The
mismatch is destructive rather than merely non-functional: Swiss reading
NWAYS sends 80 00 31 00, which the current decoder reads as 'write 0x31 to
NCRA' -- and bit 0 of 0x31 is RESET. Every register read would reset the
device. The device-ID query is the one case where the two formats coincide,
which is exactly why enumeration worked on hardware and nothing else would
have.
Also explains the 22-bit response latency measured on console: the trailing
0x00 byte in the real header is the device's prefetch window, and the current
format spends those bits on the length field, leaving zero slack. Adopting
the real format is required for compatibility anyway and recovers ~296 ns of
the ~815 ns deficit.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
SP1 DO/DI naming is console-perspective (verified against SD Gecko and
SD2SP2 wiring): pin 6 DO = GC data out = adapter MOSI input, pin 9 DI =
GC data in = adapter MISO output. The design doc's SP1 table had the
roles reversed and the schematic followed it, putting the FPGA's MISO
driver on the GC-driven DO line (bus contention).
Fix keeps all PCB routing identical:
- Swap net names EXI_MOSI(_RAW) <-> EXI_MISO(_RAW) across exi/Fpga/root
sheets and the PCB (also renames the D2 PUSB3AB6 channel assignments).
- Swap R21 (22R) <-> R25 (33R) identities between the two footprint
positions so 33R stays on the FPGA-driven MISO line, 22R on the MOSI
input.
- Correct the SP1 pin table + MISO-tristate note in
docs/gc_bba_fpga_design.md (root cause).
Resulting board pin map (for the future board PCF): EXI_MOSI = FPGA
pin 4 (IOB_8a, input), EXI_MISO = pin 3 (IOB_9b, output).
Verified: ERC 0, DRC 0 errors with schematic parity 0, netlist shows
J3.6(DO)->R21->pin 4 and J3.9(DI)->R25->pin 3.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Roflin
Dennis Brentjes