Roflin
4831c1353c
Hardware with RBFI active: "timeout mid-transfer (5 seen, 18 bad desc, 0
lapped)", plus a frame dump of "1E FF FF FF FF FF FF 00".
Three things that tells us:
- lapped = 0, so the ring is no longer being overwritten. RBFI works and
overflow is eliminated as the cause.
- got > 0 ("mid-transfer"), so some blocks DID arrive and match.
- 0x1E is 286 & 0xFF, the low byte of total_len, followed by the full
six-byte broadcast MAC and then 0x00. The frame body is intact but starts
one byte later than the reader expects.
18 of 23 frames rejected while 5 parsed in the SAME run means the offset
VARIES frame to frame -- a race in the assembler, not a constant. Simulation
does not reproduce it: T2/T5 put the descriptor at +0 and the body at +4 with
the write port both free-running and stalled 1-in-3, and the mutation controls
for both known handshake bugs fail as expected. So the cause is still unknown
and I am not going to guess at it a fifth time.
ring_next() now LOCATES the descriptor instead of assuming +0: it probes
offsets 0 and 1 and takes whichever yields a plausible length (> 4 descriptor
bytes, <= a legal frame), then reads the body and advances RRP from that same
offset. A length is a strong discriminator, so this is a measurement rather
than a guess, and it both lets the transfer proceed and COUNTS the split --
"desc@+0=N +1=M" on success and on timeout. That distribution is the
measurement needed to find the real gateware bug.
Also trimmed the on-screen guidance: the console holds ~25 lines and the
explanatory text was pushing the failure diagnostics off the top, which cost
two blind round trips. Status during a transfer is now one line, and the
menu blurb one line.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>